| October 20, 2007 |
| Rear Spars |
 |
 |
| Started the night out by priming a few of the parts for the rear spar assembly. |
 |
| Riveted the inboard section first. You can see the differences between the Left and Right rear spars. The plates are on opposite sides of the channel. Make note of this! This only applies to the inboard sections. |
 |
| Everything riveted. |
 |
| Close up of the butted pieces riveted together. You can see the cut-out for the aileron counter weight... It should fit right inside that slot. |
 |
| The Left and Right Rear Spars completed! I will store these until later... I am moving right along on this project (by my standards, anyway), the Main Spar shoud begin very soon! My goal was to start them by November... it looks like that will happen. |