| October 11, 2007 |
| Attach Blocks |
 |
 |
| Finding the correct distance for the attach block. Once found, I will clamp the block down and drill my holes. |
 |
| Once I drilled one side, I went ahead and put the bolts in. It was kind of hard to clamp it down and still have enough room to drill your holes. It is important to keep your block tight against the angle at all times when drilling. |
 |
| Attach blocks finished! |
 |
| On the same page (of the plans), are these angles. I had already made them but still needed to "fine-tune" the edges. All these angles will eventually go on the main spar. (Probably sooner than I think, getting real close now.) |