| October 20, 2007 |
| Aileron Bellcranks |
 |
 |
| The angle arrived 1 day after I ordered it, but I had to work for a couple days so I could not work on it. Here the angle is ready for the "rough-cuts." |
 |
| Copied full size drawings and pasted it to the aluminum. After cutting it to shape, I used this piece as a guide to make my "mirror" piece. |
 |
| Used double sided tape and joined the two associated parts. Then, I went ahead and drilled a 1/16" hole through both angles. As you can see, I still need to polish the edges. I finished the rear spars tonight and finally got started on these again. Cannot wait to finish them! |